How to Remove and Replace the Erde Hub Cap

This is a simple guide to removing and replacing the hub cap on the Erde aluminium hub fitted on all the Erde trailer models 100, 101, 102, 120, 121, 122, 130, 131 &132 and Daxara trailer models 106, 107, 126, 127, 136 & 137 and the Erde motorcycle trailer models PM300 and PM310.

Removing the hub cap

Removing the the Erde hubcap can be done by using either wood or rubber mallet to tap the cap on the side at as much of an angle so as to move the cap away from the hub, this should be done while turning the hub slowly. The hub cap should start moving way from the hub and then come away completely. This can be done without damaging the cap but sometimes its so stubborn that the cap can become dented and cannot be refitted and new one is required.

Replacing the Hub Cap

The cap can then be replaced, push in by hand as far as possible and the tap in the centre with a rubber mallet until fully home, this should leave about 14mm of cap above the casting.

Not Sure About Something?

Should you require any further assistance or advice please Contact Us

Disclaimer

The information is given only as a guide, if you are in any doubt you should seek professional advice. Western Towing Ltd will not assume and hereby disclaim any liability to any party for any loss or damage caused by errors or omissions, whether such errors or omissions result from negligence, accident or other cause.



Western Towing Towbar & Trailer Centres Western Towing Logo 01392 216336 3 Marsh Green Road North, Marsh Barton, Exeter, Devon, EX2 8NY Jetty Marsh Road, Newton Abbot, Devon, TQ12 2SL 4.00 to 5,000.00 is rated 4.9 stars by Reviews.co.uk based on 419 reviews